Setting Up Your Brewer - Keurig K40 Elite Owner's Manual

SECTION 1
You cannot use your Keurig
IMPorTanT:
it has been set-up for its first use as set forth below.
If brewer has been exposed to temperatures
noTe:
below freezing, allow brewer at least two hours to
reach room temperature before brewing. A frozen
or extremely cold brewer will not operate.

Setting up Your Brewer

1
fig.
Unwrap cord and plug the brewer into a
1.
grounded outlet. Remove all pieces of
packing tape.
2. Place a large mug (10 oz. minimum) on
the Drip Tray Plate.
3. Remove the Water Reservoir from brewer by
first removing Lid from Reservoir (fig. 1), then
lifting Reservoir straight up and away from
brewer (may be tight). Rinse with fresh water.
Fill Water Reservoir with bottled or filtered
4.
water so that the water is to and not beyond
the MAX FILL line.
Set-Up & First Brew
brewer until
®
5.
2
fig.
Lock Tabs
6.
3
fig.
7.
Small Mug
6
Place Water Reservoir base into the left side of
the brewer and be sure the Water Reservoir
Lock Tabs engage with the brewer (fig. 2).
Replace Lid on Water Reservoir.
Press Power Button found on upper right
panel of the brewer. The green Power Light
will illuminate.
NOTE: A K-Cup pack should
®
.
not be used for this sequence
NOTE: If the Water Reservoir is empty or
not in place on the brewer, the blue Add Water
Light will illuminate. The Small Mug Button will
not be activated until water is added to the
Water Reservoir.
The brewer will automatically fill with water and
then the water will be heated. This will take
about 4 minutes. During the heating period, the
red Heating Light will illuminate. Once the
water is heated, the red Heating Light will turn
off and the Small Cup, Small Mug and Large
Mug Buttons will illuminate.
NOTE: Do not lift
Handle during this heating period.