American Standard Heritage Bidet 5032.010 Specification Sheet

HERITAGE™ BIDET
❑ 5032.026 For deck-mounted fitting (illustrated)
• Vitreous china
• Flushing rim and vertical cleansing spray
• Integral overflow
• Concealed floor anchor bracket
• Two bolt caps
Shown with 2373.401 Enfield fitting with
handles (not included)
❑
5032.010 For over-the-rim fitting
• Vitreous china
• Punched for single hole, over-the-rim fitting,
less flushing rim and spray
• Integral overflow
• Two bolt caps
Nominal Dimensions:
654 x 359 x 362mm
(25-3/4" x 14-1/8" x 14-1/4")
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2M for Vitreous China Fixtures
To Be Specified:
❏ Color: ❏ White ❏ Bone ❏ Linen
❏ Bidet Fitting*:
❏ Fitting Finish:
❏ Trap:
❏ Supplies with Stops:
* See faucet section for additional models available
NOTES:
* DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES ARE SUGGESTED.
"P" TRAP AND FITTINGS NOT FURNISHED WITH BIDET AND MUST BE
ORDERED SEPARATELY. BIDET FITTING HAS TRANSFER VALVE
FEATURE.
●
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH BIDET AND
FITTING FOR ADDITIONAL INFORMATION.
PROVISIONS MUST BE MADE FOR THE INSTALLATION OF TRAP IN
FLOOR.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided leaflet.
© 2008 AS America Inc.
25mm (1) DIA. HOLE
(3) 35mm (1-3/8) DIA.
FOR POP-UP ROD
VALVE HOLES
FINISHED
WALL
203mm
(8)
102mm
(4)
19mm
76mm (3)
(3/4)
SUGGESTED
MINIMUM 64mm
114mm
(2-1/2)
(4-1/2)
127mm
(5)
C/L OF 3/8 HOT & COLD INLETS
73mm
(2-7/8)
VACUUM
MIN.
BREAKER
241mm
(9-1/2)
114mm
(4-1/2)
SUPPLIES
AS REQUIRED
COUPLING
NUTS ON
*
FITTING
127mm
(5)
241mm
(9-1/2)
REF.
K1
HERITAGE™ BIDET
VITREOUS CHINA
44mm (1-3/4) DIA. STD.
DRAIN OUTLET
C/L
29mm (1-1/8) DIA. HOLE
FOR SPRAY
222mm
(8-3/4)
654mm
(25-3/4)
C/L OF DRAIN OUTLET
362mm
(14-1/4)
HANGER
1-1/4 O.D. TAILPIECE
432mm 76mm
(17) (3)
C/L OF (2) 8mm (5/16) DIA. FOOT
ANCHOR HOLES ON 76mm (3") CENTERS
Revised 2/08
359mm
(14-1/8)
FINISHED
FLOOR