Upgrading the Software
Samsung may offer upgrades for your TV's firmware in the future. Please contact the Samsung
call center at 0 SAMSUNG to receive information about downloading upgrades and using a
USB drive. Upgrades will be possible by connecting a USB drive to the USB port.
Insert a USB drive containing the firmware upgrade into the
USB Upgrade Port on the side of the TV.
Press the MENU button to display the menu.
Press the ▲ or ▼ button to select Setup, then press the
Press the ▲ or ▼ button to select SW Upgrade, then
press the ENTER button.
Press the ▲ or ▼ button to select "BY USB", "BY Channel"
or "Standby Mode Upgrade". Press the ENTER button.
BY USB :
- Preset : Insert a USB drive containing the firmware
upgrade into TV.
Please be careful to not disconnect the power or
remove the USB drive while upgrades are being
applied. The TV will turn off and turn on automatically
after completing the firmware upgrade.
Please check the firmware version after the upgrades
are complete. When software is upgraded, video
and audio settings you have made will return to their
default (factory) settings. We recommend you write
down your settings so that you can easily reset them
after the upgrade.
BY Channel :
Upgrades the software using the broadcasting signal.
Standby Mode Upgrade :
To continue software upgrade with master power on, Select
On by pressing the ▲ or ▼ button.
45 minutes after entering standby mode, a manual upgrade is automatically conducted. Since the
power of the unit is turned on internally, the screen may be on slightly for the LCD product. This
phenomenon may continue for more than 1 hour until the software upgrade is completed.
Alternative Software :
To display the software version information.
English - 40
TV side Panel
standby Mode Upgrade