You can emphasize the pink tone in the picture.
Press the ◄ or ► button until you reach the optimal setting.
Changing the adjustment value will refresh the adjusted screen.
Edge Enhancement: Off/On
You can emphasize object boundaries.
Setting the xvYCC mode to On increases detail and colour space when watching movies from an
external device (ie. DVD player) connected to the HDMI or Component IN jacks. You must set the
Picture Mode to Movie to enjoy this feature.
The xvYCC function works only in Component or HDMI mode.
You can set detailed picture settings.
Press the MENU button to display the menu.
Press the ENTER button to select Picture.
Press the ▲ or ▼ button to select Picture Options, then
press the ENTER button.
Select the required option by pressing the ▲ or ▼ button,
then press the ENTER button.
When you are satisfied with your setting, press the ENTER
Press the EXIT button to exit.
In PC mode, you can only make changes to the Colour
Tone, Size and Screen Burn Protection from among the
items in Picture Options.
Colour Tone: Cool/Cool1/Normal/Warm1/Warm
When the picture mode is set to Dynamic or
Standard, Warm1 and Warm cannot be selected.
Size: 1:/Wide Zoom/Zoom/4:/Just Scan
You can select the picture size which best corresponds to
your viewing requirements.
− 1:: Sets the picture to 16:9 wide mode.
− Wide Zoom: Magnify the size of the picture more than 4:3.
Move the screen up/down using the ▲ or ▼ button after
− Zoom: Magnify the size of the picture vertically on screen.
− 4:: Sets the picture to 4:3 normal mode.
− Just Scan: Use this function to see the full image
without any cutoff when HDMI(720p/1080i/1080p),
Component(1080i/1080p) signals are input.
After selecting Just Scan in HDMI (100i/100p) or
Component (100i/100p) mode: Press the ◄ or ►
button to select Position, then press the ENTER button.
Press the ▲, ▼, ◄ or ► button to move the picture.
Reset: Press the ◄ or ► button to select Reset, then press the ENTER button. You can initialize
With the HDMI Just Scan picture size, depending on the AV devices, the screen may be cut off
or a specific colour appears on the screen.
For an HDMI (1080p) connection of 24, 25, 30, 50, and 60 Hz, and for a Component (1080p)
connection of 50 and 60Hz, only the input source is supported.
You can change the picture size simply by pressing the P.SIZE button on the remote control.
Depending on the input source, the picture size options may vary.
The items available may differ depending on the selected mode.
When Double ( ,
In PC Mode, only "16:9" and "4:3" mode can be adjusted.
If you use the "Just Scan" function with HDMI 720p input, 1 line will be cut at the top, bottom, left
and right as in the overscan function.
by pressing the ► or ENTER button.
) mode has been set in PIP, the Picture Size cannot be set.
HDMI Black Level
Blue only mode