Impex IRON GRIP STRENGTH TSA-9900 Owner's Manual page 26

STEP 15 (See Diagram 15)
A.) Attach a Short Chain (#88) to the open bracket on the Power Station Vertical Frame
(#7). Secure it with one M10 x 1" Allen Bolt (#94), two Ø ¾" Washers (#109), and one
M10 Aircraft Nut (#106).
B.) Connect the 94" Vertical Press Cable (#39) to the Short Chain with a C-clip (#89).
C.) Install a Pulley to an Angled Floating Pulley Bracket (#31).
D.) Draw the Cable around the Pulley then upward to the first open bracket on the Top
Socket Assemble (#9).
E.) Install a Pulley to the bracket with a L-shaped Cable Retainer (#60). Draw the Cable
over the Pulley to the second open bracket. Repeat the same procedure to install
another Pulley.
F.) Draw the Cable around the Pulley then downward to the Selector Rod (#53). Attach
the ring on the Selector Pin (#62) to the Selector Rod. Securely thread the end of the
Cable into the Selector Rod. Use the Nut at end of the Cable to tighten down the Bolt.
G.) After completing the cable installations, come back to this step and adjust the length
of the Short Chain (#88). If the cables are too loose, shorten the Chain.
25