Impex IRON GRIP STRENGTH TSA-9900 Owner's Manual page 23

STEP 13 (See Cable Loop Diagram & Diagram 13)
A.) Attach the 146" Lower Cable (#35) to the lower opening on the Leg Developer (#26).
Attach a Pulley (#64) to the opening. Secure it with one M10 x 2 3/8" Allen Bolt (#96), two
Pulley Bushings (#63), and one M10 Aircraft Nut (#106).
B.) Draw the Cable underneath the Pulley to the opening on the bottom of Right Seat Support
(#10). Attach a Pulley to the opening and secure it with one M10 x 2 3/8" Allen Bolt (#96),
two Pulley Bushings (#63), and one M10 Aircraft Nut (#106).
C.) Draw the Cable underneath the Pulley then through the bottom opening on the Right
Vertical Frame (#5) to the second open bracket on the Right Base Frame (#1).
D.) Attach a Pulley to the second open bracket. Secure it with one M10 x 1 ¾" Allen Bolt
(#95), two ¾" Washers (#109), and one M10 Aircraft Nut (#106).
E.) Draw the Cable around the Pulley then upward to the Double Floating Pulley Bracket (#32)
previously installed in Step-11. Install a Pulley to the Brackets on selected hole. After
completing all the Cable installation, come back to this step and check the tension of the
Cable loop system. If the cables are too loose, move up the Pulley on the Bracket. Move
down the Pulley if the Cables are too tight.
F.) Draw the Cable around the Pulley then downward. Install a Pulley to an Angled Floating
Pulley Bracket (#31).
G.) Draw the Cable around the Pulley then upward to the Angled Floating Pulley Bracket (#31)
previously installed in Step-12. Secure the Cable to the Bracket with one M10 x 1" Allen
Bolt (#94), two Ø ¾" Washers (#109), and one M10 Aircraft Nut (#106).
22