Indicator Light On The Charging Station - Husqvarna AUTOMOWER 305 Operator's Manual

9.2 Indicator light on the charging station

For a fully functional installation, the indicator light on the charging station must emit a solid green light. If
something else appears, follow the troubleshooting guide below.
There is more troubleshooting help on www.automower.com. If you still need help with troubleshooting,
please contact the local dealer.
Light
Solid green light
Blue flashing light
Yellow flashing light
Red flashing light
Blue solid light
Red solid light
9. TROUBLE SHOOTING
Cause
Everything in order
The boundary loop is not connected
to the charging station
Break in the boundary loop
The guide wire is not connected to
the charging station
Break in the guide wire
Interruption in the charging station's
antenna
Weak signal as the boundary wire is
too long. Max length is 820 feet
(250 metres).
Weak signal due to damaged
boundary wire
Defective circuit card in the charging
station
Action
No action required
Check that the boundary wire
connector is fitted properly to the
charging station. See 3.5 Connecting
the boundary wire on page 27.
Find out where the break is. Replace
the damaged section of the loop with
a new loop wire and splice using an
original connector.
Check that the guide wire connector
is properly connected to the charging
station. See 3.6 Installation of the
guide wire on page 28.
Find out where the break is. Replace
the damaged section of the loop with
a new loop wire and splice using an
original connector.
Contact the local dealer.
No steps have to be taken if the
mower operates as expected.
Shorten the boundary wire by
reducing the working area or
replacing islands with barriers with
which the mower can collide.
Since it is difficult to locate where the
wire is damaged it is recommended
to lay a new boundary wire for the
entire working area.
Contact the local dealer.
English - 61