INSTALLATION INSTRUCTIONS
7.
Install the kit mulching blades using the existing
blade bolt (torque to 90 ft./lbs.).
8.
Rotate the blades by hand and check for
clearance of all baffles.
9.
Make sure all hardware is tight.
10.
Remove blocks and return the mower to its normal
position.
Mulching Guidelines
To ensure acceptable mulching performance:
•
The length of grass to be cut in one pass
should not exceed
Example: If grass height is 3", the mower deck
cutting height should be set at not less than 2".
•
Ground speed should normally be reduced to
allow clippings to be finely mulched.
•
Engine RPM should be set at maximum.
•
Blades must be kept sharp.
•
The underside of deck should be cleaned out
often to prevent grass accumulation.
•
Conditions must be dry. Wet grass does not
mulch well and grass accumulates under deck.
P/N 115 152827 R1
08/15/09
/
of the total grass height.
1
3