AEG CS FMP200 Owner's Manual: Installation; Take Out Screw Before Installation; Din Front-mount (method A); Installing The Unit

Mobile audio system.
Hide thumbs

Advertisement

INSTALLATION

Notes:
Choose the mounting location where
the unit will not interfere with the
normal driving function of the driver.
Before finally installing the unit,
connect the wiring temporarily and
make sure it is all connected up
properly and the unit and the system
work properly.
Use only the parts included with the
unit to ensure proper installation. The
use of unauthorized parts can cause
malfunctions.
Consult with your nearest dealer if
installation requires the drilling of
holes or other modifications of the
vehicle.
Install the unit where it does not get
in the driver's way and cannot injure
the passenger if there is a sudden
stop,like an emergency stop.
If installation angle exceeds 30 from
horizontal, the unit might not give its
optimum performance.
Avoid installing the unit where it would
be subject to high temperature, such
as from direct sunlight, or from hot air,
from the heater, or where it would be
subject to dust, dirt or excessive
vibration.
DIN FRONT/REAR-MOUNT
This unit be can properly installed either
from "Front"(conventional DIN
Front-mount) or "Rear"(DIN Rear-mount
installation, utilizing threaded screw holes
at the sides of the unit chassis). For
details, refer to the following illustrated
installation methods.
O
30
TAKE OUT SCREW BEFORE
INSTALLATION
Before install the unit, please remove
the two screws .
Take out screw
before installation
DIN FRONT-MOUNT (Method A)
Installation Opening
This unit can be installed in any
dashboard having an opening as show
below:
Installing the unit
Be sure you test all connections first, and
then follow these steps to install the unit.
1.
Make sure the ignition is turned off,
and then disconnect the cable from the
vehicle battery's negative (-) terminal.
Disconnect the wire harness and the
2.
antenna.
Press the release button on the front
3.
panel and remove the control panel
(see the steps of "removing the front
panel").
Lift the top of the outer trim ring then
4.
pull it out to remove it.
The two supplied keys release tabs
5.
inside the unit's sleeve so you can
remove it. Insert the keys as far as
they will go (with the notches facing
up) into the appropriate slots at the
3
182mm
53mm

Advertisement

   Related Manuals for AEG CS FMP200

This manual also for:

Cs fmp 200

Comments to this Manuals

Symbols: 0
Latest comments: