Advertisement

Menu Selection and Settings
I
NTRODUCTION
In earlier chapters, basic and advanced operation
were covered to explain the various transceiver fea-
tures. This chapter covers all of the menu selections
entries and their settings used by the transceiver. These
functions were described previously, but must be con-
figured as desired using menu programming. Menu
selections are shown as they appear in the display to
assist you as you go along.
M
S
ENU
ELECTIONS
Eighty-two transceiver settings are contained in pro-
gramming menu (refer to the menu list shown on the
opposite page).
r To enter the "Menu" mode, press and hold in [ FAST ] ,
then press [ ENT ] .
r The SUB VFO-B display will show the selection
name, while the Main VFO display field shows the
current setting for the selected menu item.
r Rotating the VRF/MEM CH knob displays the vari-
ous menu selections, whose numbers appear in the
memory channel box.
r Rotating the Main VFO knob, once you have se-
lected a menu item, lets you choose between the
various settings available for the displayed selec-
tion. Some settings are merely an off/on switch,
while others are variable tuning step sizes, time and
frequency values, or mode choices.
Easy Recall Menu
Several menu selections can be accessed directly
via two keystokes from the front panle:
[ FAST ] + [ NB ]
[ FAST ] + [ NOTCH ]
[ FAST ] + [ VCC/MIC ]
[ FAST ] + [ BK-IN ]
[ FAST ] + RX- ( SUB VFO-B ) Menu 8-7 (Sub-AGc)
page 98
Menu 2-8 (nb)
Menu 2-9 (notch)
Menu 3-4 (briGHt)
Menu 7-5 (kyr-dLy)
0-1 GrP1-cH
Selects the number of default memory channels
(from 1-99) available within Memory Group 1. If all 99
memory channels are enabled, Memory Group 2 is not
configurable.
0-2 GrP2-cH
Selects the number of memory channels (from 1-
99) available within Memory Group 2 (if less than 99
memory channels are enabled in Memory Group 1). If
all 99 memory channels are enabled, Memory Group
3 is not configurable.
0-3 GrP3-cH
Selects the number of memory channels available
within Memory Group 3 (if Groups 1 and 2 are not con-
figured for 99 channels total). If all 99 memory chan-
nels are enabled, Memory Group 4 is not configurable.
0-4 GrP4-cH
Selects the number of memory channels available
within Memory Group 4 if Groups 1, 2, and 3 are not
configured for 99 channels total. If all 99 memory chan-
nels are enabled, Memory Group 5 is not configurable.
0-5 GrP5-cH
Selects the number of memory channels available
within memory Group 5 (to 99 total) if Groups 1, 2, 3,
and 4 are not configured for 99 channels total.
0-6 quick-cH
Quick Memory Bank Channels - Allocates 1 to 5
memories for use with the instant-write "quick-memory"
feature.
0-7 (Not Used)
MARK-V FT-1000MP Operating Manual

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: