Whirlpool 8178501A Manual page 20

Fast fill dispenser system
Table of Contents

Advertisement

12. To remove the IDI motor:
a) Open the freezer door.
b) Press in on the release button and re-
move the ice bin from the door shelf.
Ice Bin
Release Button
c) Remove the two screws from the hex
drive shaft coupling holder and remove
the coupling assembly.
Shaft Coupling Holder Screws
d) Lift the spring and hex drive shaft up
and out of the door.
Spring
Hex Drive Shaft
e) Remove the boot from the top of the
IDI motor.
f) Disconnect the motor connector from
the IDI motor.
g) Unclip the wires from the retainers under
the IDI motor housing.
h) Remove the three screws from the IDI
motor housing and remove the motor
and housing from the dispenser.
Screws
i) Remove the four screws from the IDI
motor and remove the motor from the
housing.
Screw (1 of 4)
3-6
Boot
IDI Motor
Connector
Wire Retainers
IDI Motor
Screw

Advertisement

Table of Contents
loading

This manual is also suitable for:

R-101

Table of Contents