Advertisement
QuickSpecs
Standard Features
Bluetooth®
1
Specifications
Modulation Schemes
Receiver Sensitivity –
Packet Error Rate
(8E-2)
Maximum Receive Level
Output Power
Power Management
Power Consumption
Power Saving Option
Media Access Protocol
Protocols Supported
Operating Distance
Certifications
NOTES:
1
A standard WLAN (Wi-Fi) infrastructure, other Bluetooth-enabled devices, separately purchased
equipment, and a service contract with a wireless airtime provider may be required for applicable wireless
communication. Wireless Internet use requires a separately purchased service contract. Check with
wireless network service providers for availability and coverage in your area. Not all web content
available.
5
Wireless access point required and is not included. Availability of public wireless access points limited.
Wireless Internet use may require separately purchased Internet service contract.
Technology
Bluetooth specification
System interface
User Interface
Device type
Power
Receiver sensitivity
DA - 12984 Worldwide — Version 5 — March 24, 2008
DBPSK, DQPSK, CCK
11 Mbps: <-80 dBm
5.5 Mbps: <-82 dBm
2 Mbps: <-86 dBm
1 Mbps: <-89 dBm
-10dBm (1/2/5.5/11 Mbps)
15 dBm
Radio On/Off control through iPAQ wireless
Power Save mode available in Power Settings
Transfer mode: < 300 mA, average
Receive mode: < 200 mA, average
802.11 Compliant Power Saving, idle mode 20 mA
CSMA/CA (Collision Avoidance) with ACK
TCP/IP
IPX/SPX
UDP
Up to 1000 feet – Open sight
All necessary regulatory approvals for countries we support including:
WECA Wi-Fi approval
FCC (47 CFR) Part 15C, Section 15.247&15.249
ETS 300 328, ETS xxx 489-6
Low Voltage Directive IEC950
UL, CSA, and CE Mark
High-speed, low-power, short-range wireless communication with other
Bluetooth devices
1.2 compliant (2.4-GHz Industrial Scientific Medical Band)
High-speed UART processor interface
Bluetooth Manager
Class II device; up to 4 dBm transmit, typical 10 meter range
3.3V 5% Peak current
-83 dBm
HP iPAQ hx2790c Pocket PC
– typical TX current at approximately 30 mA
– typical RX current at approximately 50 mA
Page 7
Advertisement
