Fujitsu Stylistic Manual page 61

Printer Sharing
1. Press [Start]->[Control Panel] (or [Settings], if
viewing in Classic mode)-> [Printers and
Faxes]. The Printers and Faxes display will
appear and the connected printers will be
displayed.
2. Right-click the printer to be shared, and click
[Sharing] from the menu that appears. The
properties of the printer to be shared will be
displayed. Set printer sharing.
On the display, the printer sharing setting is
recommended by the Network Setup Wizard,
but for the wireless LAN network, security is
maintained by network name (SSID) or
network key. The following steps allow you to
set up printer sharing without using the
Network Setup Wizard.
3. Click 'If you understand the security risks but
want to share printers without running the
wizard, click here. 'Enable Printer Sharing' will
be displayed.
4. Select 'Just enable printer sharing'.
5. Click 'OK'. The printer properties will be
indicated.
6. Select 'Share this printer'.
7. Enter the sharing printer name in 'Share
name'.
8. Click OK. The printer will be shared, and the
printer icon will become a sharing icon.
Checking the Connection
After the network setting is completed, access
the shared drive on another computer to check
the connectivity of the wireless LAN network.
Accessing Another Computer
1. Click [Start] -> [My Computer].
2. From the left menu in [Other Places], click
[My Network Places].
3. From the left menu in [Network Tasks], click
[View workgroup computers]. The workgroup
in which you are participating will appear.
4. Double click the computer to which you want
to connect. The drive that you set in
[Computer Sharing] appears.
5. Double click the drive to which you want to
connect. The contents of the drive will appear,
and is available for use.
W i r e l e s s L A N U s e r 's G u i d e
If you have a question or problem, refer to
"Troubleshooting Table" on page 54.
Checking the Connectivity
1. Click [Start] -> [Control Panel].
2. Double-click the [PRISM Settings] icon.
[PRISM Wireless Setting] appears.
3. Check the connectivity on the [Link] tab. The
current condition of connection is displayed.
Description
Item
Shows the current condition of
State
connection.
The MAC address of the other
computer that you are
connected to is displayed, when
the connection is successfully
made. If you are connected to
more than one computer, the
computer that has the best
connectivity is displayed.
Shows the current channel used
Current
for the connection.
Channel
Shows the current transfer rate
Current Tx
in Mbits/sec.
Rate
Click [Radio OFF] to disconnect.
Radio Off/
Radio On
Click [Radio On] to connect to
the network.
Rescan
Click this button to search for
others to connect to.
Throughput
Shows the actual transfer rate of
(Bytes/sec) the transfer data for send (Tx)
and receive (Rx).
Shows the link quality. This is
Link
not shown for the AdHoc
Quality
connection.
Shows the signal strength.
Signal
Strength
This is not shown for the AdHoc
connection.
Table 11: Checking connectivity
53