3. Open theshutoff v alve inthegassupply line.
4. Test a llconnections bybrushing o na soapy w atersolution.
NEVER TEST FOR GAS LEAKS WITH AN OPEN FLAME.
1. Form a " U " shape on the end of the drain hose with the
hose pointed toward the drain. Place the formed end in a
laundry tub or a standpipe and secure with a cable tie
provided in the enclosure package. An air gap must ne
around the drain hose. WATER WILL SIPHON FROM THE
WASHER IF THE ABOVE INSTRUCTIONS
Remove the two (2) screws securing the dryer front
access panel to the dryer cabinet. Lift the panel until the tabs
can be disengaged from the cabinet. Remove the
panel and set aside.
3. Turn on the power at a circuit breaker/fuse box.
Before operating the dryer, make sure the
dryer area is clear and free from combustible materials, gasoline,
and other flammable vapors. Also see that nothing (such as
boxes, clothing, etc.) obstructs the flow of combustion and
4. Reinstall the dryer front access panel.
5. Run the washer and dryer though a cycle. Check for
NOTE: On gas dryers, before the burner will light, it is
necessary for the gas line to be bled of air. If the burner
does not light within 45 seconds the first time the dryer is
on, the safety switch
will shut the burner off. If
this happens, turn the timer to "OFF" and wait 5 minutes
before making another
6, If your laundry center does not operate, please review the
"Avoid Service Checklist" located in your Owner's Guide
before calling for service.
7. Place these instructions in a location near the laundry
center for future reference.
NOTE: A wiring diagram is located behind the dryer front access
If replacement parts are needed for your laundry center, contact
the source where you purchased your laundry center,
Destroy the carton, plastic bags, and metal
band after the laundry center is unpacked, Children might use
them for play, Cartons covered with rugs, bedspreads, or plastic
sheets can become airtight chambers causing suffocation, Place
all materials in a garbage container or make materials inaccessible
Label all wires prior to disconnection when
Wiring errors can cause improper
dangerous operation. Verify proper operation after servicing.
instructions in this manual and all other
literature included with this laundry center are not meant to
cover every possible condition and situation that may occur. Good
safe practice and caution MUST be applied when installing,
operating and maintaining any appliance.
Connect the exhaust duct to outside duct work. Use duct
tape to seal all joints.
2. Plug the power cord into a grounded outlet.
NOTE; Check to ensure the power is off at a circuit breaker
fuse box before plugging the power cord into an outlet.
Maximum benefits and enjoyment are achieved when all
the Safety and Operating instructions are understood and
practiced as a routine with your laundry tasks,