Download  Print this page

Mobile Home Installation; Unpacking - Frigidaire CLCG900FW3 Installation Instructions Manual

Full size laundry center gas & electric
Hide thumbs

Advertisement

Table of Contents
MOBILE
HOME
INSTALLATION
1. Dryer MUST be exhausted outside (outdoors,
not
beneath the mobile home) using metal
ducting that will not support combustion. Metal
ducting
must
be 4 inches (10.16
cm)in
diameter with no obstructions. Rigid metal duct
is preferred.
UNPACKING
1. Using the four shipping carton corner posts (two on each side), carefully
lay the laundry center on its left side and remove the foam shipping
base.
_
Excessive weight.
Use two or more
people to
--
move Laundry
Center.
2. If dryer is exhausted through the floor and area
beneath the mobile home is enclosed, the
exhaust system MUST terminate
outside the
enclosure with the termination securely fastened
to the mobile home structure.
X
iilil
i
I,q,!,!,!,!,,!
i,,_@iw!
_
,
,
3. Refer to page 3 for other important
venting
requirements.
4. When installing a gas dryer into a mobile home,
a provision must be made for outside make up
air. This provision is to be not less than twice
the area of thedryer exhaust outlet.
5. Installation
MUST
conform
to
current
Manufactured
Home Construction
& Safety
Standard (which is a Federal Regulation Title
24 CFR-Part 32-80) or when such standard is
not applicable, with American National Standard
for Mobile Homes. In Canada, the CSA Z240 is
applicable.
The laundry center is designed
under ANSI Z 21.5.1 for
HOME USE only.
FOAM
SHIPPING
PAD
,
3.
,
,
,
,
,
9.
Return laundrycenter to an upright position.
Remove the following from
the
back
side
of
the
washer:
4 bolts,
4 yellow plastic spacers,
3 metal "P" clamps.
Remove the service panel
from
the front
of the
washer.
Remove the 4 nuts and 6
large washers that attach
the
2 yellow
shipping
braces to the
drum and
the base. Lift up on the
drum
and remove
the
braces (a yellow
ribbon
surrounds the items to be
removed).
Remove the large
styrofoam block located
under the drum. Lift up on
the drum, tilt the base of
the foam block inwards
toward the rear of the
washer until free, then pull
it out.
Remove and discard the
yellow ribbon
and label
from
the front
of the
washer.
Replace the service panel
and screws.
Carefully move the laundry
center to within
4 feet
(1.22m) of the final location
to begin the installation.
NOTE: If the laundry
f_
center is to be
_
o
transported at a later
date, the shipping
support hardware must
be reinstalled to prevent
shipping damage.
®
®
CARTON CORNER POSTS

Advertisement

Chapters

Table of Contents
loading

  Related Manuals for Frigidaire CLCG900FW3

This manual is also suitable for:

Clce900fw2Gleh1642fs4Glgh1642fs3Gleh1642fs2Glgh1642fs2Clcg900fw2 ... Show all