Husqvarna 1650EXLT Operator's Manual page 21

SERVICE AND ADJUSTMENTS
STEERING
CLUTCH
NOTE: Figure 33 shows the bellcrank positioned too low,
causing hard disengagement or self-disengagement while
driving.
NOTE: Figure 34 shows the bellcrank positioned correctly.
The bottom of the bellcrank is horizontal, in a position paral-
lel to the top of the steering clutch. The steering yoke top
edge is in line with the middle of the flat vertical surface of
the bellcrank. Figure 35 shows an end view of the bellcrank
in the correct position.
STEERING BELLCRANK
STEERING
YOKE
HIGH
POSITION
FIG. 32
LOW
POSITION
FIG. 33
STEERING BELLCRANK
STEERING
YOKE
CORRECT POSITION -
HORIZONTAL
FIG. 34
STEERING BELLCRANK
STEERING YOKE
4. Adjust the position of the steering bellcrank by turning
the adjuster to raise or lower the bellcrank. When the
bellcrank is positioned correctly, replace the plastic
power steering cover and the wheel or track.
5. Repeat the procedure for the opposite side.
21
VERTICAL
SURFACE
FIG. 35