Honeywell HD-JC-010 User Manual page 34

Honeywell
ID: *3
Dev name: DVR-1
Dev type: DVR
Connection type: RS232
ID:
If there is a * before the ID number (such as *3), it means this front device has control point
setup.
You can view device *3 corresponding type and name.
Device name:
Here is for you to give a name to the front device.
Device type
There are several selections such as DVR/Dome/CMS/NVS. You can use left/right key to
select device type and then click up/down to go on setup.
Connection type
Please use up/down to highlight connection type and then use left/right to select type.
Click "ENTER" to set the following items:
232 address
Parity
Protocol
Stop bit
Baud rate
Data bit
232 Add: 8
Protocol: DH2
Baud rate: 9600
Data bit: 8
Note: 232 address and 485 address are corresponding DVR local number.
DH2 is network keyboard/2
serial port protocol is network keyboard protocol.
28
Parity: None
Stop bit: 1
nd
generation control keyboard protocol, its corresponding DVR