Table of Contents
Advertisement
STANDARD TELEPHONE
2. Dial
*
4.
To Initiate a Conference:
1. Flash the hookswitch.
2. Dial the desired number.
3. Flash the hookswitch when the
new party answers.
To Return to the Original
Connection:
1. Flash the hookswitch.
To Consult with Another Party:
1. Flash the hookswitch.
8
You will be connected to any call that is ringing at any station in your
group.
NOTE: Calls can only be picked up from an idle station. Calls ringing on
a secondary DN cannot be picked up if that station's primary DN is busy.
CONFERENCING
It is possible to create a three-party conference by adding another station
or trunk party to an existing two-party conversation. Any of the three
parties may disconnect at any time, leaving the remaining two parties
connected. (The system will refuse to connect certain types of trunks.)
The original connection will be placed on hold, and you will hear recall
dial tone.
NOTES:
1. If you hear a busy tone after dialing the station number or trunk
access code, flash the hookswitch
2. To return to the original call after accessing a trunk, flash the
hookswitch twice.
A three-party conference will now be established.
The third party will be released and the original connection will remain.
CONSULTATION CALL
This feature enables you to consult with an inside or outside party while
you hold another call.
The original connection will be placed on hold, and you will hear recall
dial tone.
PERCEPTION
once to return to the original call.
e&ex
Advertisement
Table of Contents
