Electrolux W365H Service Manual page 156

23
START EXTRACT SPEED
DEFAULT WASH ACCELERATION
DISTRIBUTION ACCELERATION
RETARDATION ACCELERATION
EXTRACT ACCELERATION
START EXTRACT ACCELERATION
EXTRACT RETARDATION
MAX SPEED DURING FILLING
MAX LEVEL OFFS FOR AUT. CALIB.
TIME AT DISTRIBUTION SPEED 2
NUMBER OF REDIST LOW 1 UNB.
NUMBER OF REDIST LOW 2 UNB.
NUMBER OF REDIST MEDIUM UNB.
NUMBER OF REDIST HIGH UNB.
NUMBER OF REDIST EXTREME UNB.
DRAIN TIME AT PROGR. START
DRAIN TIME AT PROGR. END
READY
1
4
7
START EXTRACT SPEED
DEFAULT WASH ACCELERATION
DISTRIBUTION ACCELERATION
RETARDATION ACCELERATION
EXTRACT ACCELERATION
START EXTRACT ACCELERATION
EXTRACT RETARDATION
MAX SPEED DURING FILLING
MAX LEVEL OFFS FOR AUT. CALIB.
TIME AT DISTRIBUTION SPEED 2
NUMBER OF REDIST LOW 1 UNB.
NUMBER OF REDIST LOW 2 UNB.
NUMBER OF REDIST MEDIUM UNB.
NUMBER OF REDIST HIGH UNB.
NUMBER OF REDIST EXTREME UNB.
DRAIN TIME AT PROGR. START
DRAIN TIME AT PROGR. END
READY
1
4
7
70
23. Programme unit
1000
20
9
40
40
50
100
Use the numeric keys to
2 3
enter the value.
5 6
8 9
If you make a mistake while
entering digits:
0
Press ERASE.
When you have finished:
Press .
1000
20
9
40
40
50
100
Use the numeric keys to
2 3
enter the value.
5 6
8 9
If you make a mistake while
entering digits:
0
Press ERASE.
When you have finished:
Press .
Extract retardation (i.e. Deceleration rate
after extraction)
Here you determine the deceleration rate (rpm/
second) at which the drum will slow down after
extraction speed. This value is not programmable
when you create a wash program. Instead the
machine always uses the value you set here.
Max. speed during filling
Here you specify a speed which the motor must
drop below when it is being braked after extraction.
Water filling will not take place until the motor has
slowed to this speed. This function is useful for
frequency-controlled motors.
Another function, intended primarily for motors
without frequency control, is called "ROLLOUT
TIME" (accessed via SETTINGS 2, described
earlier in this section). ROLLOUT TIME allows you
to specify a time period which must elapse before
water filling starts.
If these functions are combined, you must ensure
that the "rollout time" will have ended before water
filling is allowed to begin, regardless of whether
the drum speed has, prior to that, dropped below
the speed specified in "MAX. SPEED DURING
FILLING".
Rollout time, if activated/
implemented may change the
time at which filling starts
Speed
Maximum
speed while
filling
Extraction
Service
Manual
Time
Water
filling
Rinse
438 9145-41/03
03.11