Electrolux W365H Service Manual page 145

Service
Manual
OIL LUBRICATION HOURS
PULSE TIME OIL LUBR. SEC
AMOUNT OF I/O MODULES (1-3)
DELAY CLEAR DOOR TEXT
MAX DRAIN TIME
TIMEOUT DURING PAUSE
MINIMUM TEMPERATURE INCREASE
DOOR OPEN DELAY FOR MOTOR LOST
ERROR, NO WATER
ERROR, OPEN DOOR
ERROR, DOOR LOCK
ERROR, LOW TEMPERATURE
ERROR, HIGH TEMPERATURE
ERROR, WATER IN MACHINE
1
4
7
PULSE TIME OIL LUBR. SEC
AMOUNT OF I/O MODULES (1-3)
DELAY CLEAR DOOR TEXT
MAX DRAIN TIME
TIMEOUT DURING PAUSE
MINIMUM TEMPERATURE INCREASE
DOOR OPEN DELAY FOR MOTOR LOST
ERROR, NO WATER
ERROR, OPEN DOOR
ERROR, DOOR LOCK
ERROR, LOW TEMPERATURE
ERROR, HIGH TEMPERATURE
ERROR, WATER IN MACHINE
1
4
7
438 9145-41/03
03.11
23. Programme unit
100
0:01
3
04:00
4:00
1:00
5°C
1:00
Y
Y
Y
Y
Y
Y
Use the numeric keys to
2 3
enter the value.
5 6
8 9
If you make a mistake while
entering digits:
0
Press ERASE.
When you have finished:
Press .
0:01
3
04:00
4:00
1:00
°
5 C
1:00
Y
Y
Y
Y
Y
Y
Use the numeric keys to
2 3
enter the value.
5 6
8 9
If you make a mistake while
entering digits:
0
Press ERASE.
When you have finished:
Press .
Timeout during pause
Here you determine the maximum time for a pause
in the program, if it is to be available for use in
calculating the average length of the program.
991 NORMAL 95°C STD
PROGRAM STEP: MAIN WASH
STEP TIME:
SET TEMPERATURE:
ACTUAL TEMPERATURE:
REMAINING TIME:
DRUM SPEED:
RAPID ADVANCE
PAUSE
The time shown on the display alongside
"REMAINING TIME" is based on the average of
the last five times this program was used. This
time also includes pauses in the program. If the
pause time in the program exceeds the time
parameter you have programmed, it will not be
used for average-time calculation derived from the
current program operation.
Minimum temperature increase
Here you determine the smallest temperature
increase allowed during the time specified in
MAXIMUM HEATING TIME (see below).
These three functions are linked:
The following two functions also affect the way in
which the machine is controlled during heating:
MAXIMUM HEATING TIME (SETTINGS 1)
Here you determine the maximum time it may
take to heat the water the number of degrees you
have specified above.
The function ERROR, NO HEAT (SETTINGS 2)
If you answer Y (Yes):
If the temperature has not increased by the
number of degrees you program here over the
time which is specified in MAXIMUM HEATING
TIME, the error message NO HEATING will
appear on the display.
If you answer N (No):
Monitoring of heating will be switched off, and
no error message will be displayed.
23
1
720 SEK
85 °C
21 °C
70 MIN
48 RPM
SELECT
59