Download  Print this page

Husqvarna LTH1538/96043003802 Owner's Manual page 7

Ride-on mowers
Hide thumbs

Advertisement

Table of Contents
INSTALL SEAT (See Figs. 3 and 4)
Remove bolt and flat washer se cur ing seat to cardboard
packing and set aside for as sem bly of seat to tractor.
Remove the cardboard packing and discard.
Connect switch to seat.
Place seat on seat pan so all three (3) bottom pads
are positioned over large slotted holes in pan.
SEAT
SWITCH
PAD
SLOT
SEAT
PAN
Push down on seat to engage pads in slots and pull
seat towards rear of tractor.
Raise seat and tighten bolt securely.
Remove tape and discard.
Lower seat into operating position and sit on seat.
Press clutch/brake pedal all the way down. If operating
position is not comfortable, adjust seat.
To adjust seat: Grasp adjustment handle and pull up, slide
seat to desired po si tion and release adjustment handle.
SLOT
PAD
FLAT
WASHER
SEAT PAN
BOLT
TAB
ASSEMBLY
WIRING HARNESS
Fig. 3
ADJUSTMENT
HANDLE
Fig. 4
NOTE: You may now roll or drive your tractor off the skid.
Follow the ap pro pri ate instruction below to remove the
tractor from the skid.
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op er a tion
section for location and function of con trols)
Raise attachment lift lever to its highest po si tion.
Release parking brake by de press ing clutch/brake
ped al.
Place freewheel control in "trans mis sion dis en gaged
position" (See "TO TRANS PORT" in the Op er a tion
section of this manual).
Roll tractor forward off skid.
Remove banding holding the deflector shield up against
tractor.
TAPE
TO DRIVE TRAC TOR OFF SKID (See Op er a tion
section for location and function of con trols)
Be sure all the above assembly steps have been com-
pleted.
Check engine oil level and fill fuel tank with gasoline.
Place freewheel control in "trans mis sion en gaged"
po si tion (See "TO TRANSPORT" in Op er a tion section
of this manual).
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
Place motion control lever in neutral position.
Raise attachment lift lever to its highest position.
Remove key from bag and start the engine (See "TO
START ENGINE" in the Operation section of this
manual). After engine has started, move throttle control
TAPE
to idle (slow) position.
Release parking brake.
Slowly move the mo tion control lever for ward and slowly
drive tractor off skid.
Apply brake to stop trac tor, set park ing brake and place
motion con trol lever in neutral po si tion.
Turn ignition key to "STOP" position.
Continue with the in struc tions that follow.
7

Advertisement

Table of Contents
loading

  Related Manuals for Husqvarna LTH1538/96043003802

This manual is also suitable for:

Lth153896043003802