Cycle Takes a Long Time
• Is cycle in a water heating delay?
• Check incoming water temperature. It should be 120°F
(49°C).
• Has the delay start option been selected?
Dishwasher Won’t Fill
• Is water supply turned on?
• Does overfill protector move up and down freely? (See
Overfill Protector section.)
• The normal full water level of the dishwasher will only
reach the bottom of the heater clips.
Dishwasher Has an Odor
• Soiled dishes left in dishwasher too long can create an
odor.
• There will be a “new” smell when first installed. This is
normal.
• Check to see if unit is draining properly. (See
Dishwasher Does Not Drain Properly.)
Stains on Tub Interior
• Washing large amounts of dishware with tomato based
soil can cause a pink/orange appearance. This will not
affect performance and will gradually fade over time.
Pre-rinsing will reduce the chance of staining. Using the
heat dry off option will lessen staining.
Removing Spots and Film
Hard water can cause lime deposit buildup on the
interior of the dishwasher. Dishes and glasses may also
get spots and film for a number of reasons. (See
Glassware/Flatware Spotted or Cloudy section.) To
remove buildup, spots and film, clean using the
following instructions:
1.
Load clean dishes and glasses in normal manner.
Do not load any metal utensils or silverware.
2. Do not add detergent.
3. Select the HEAVY WASH cycle. Close and latch
door.
4. Allow dishwasher to run for 20 minutes to reach the
main wash portion of cycle.
5. Unlatch and open door and pour 2 cups
of white vinegar into the bottom of dishwasher.
6. Close and latch door and allow cycle to finish.
Note:
Note:
Note:
Note: If these conditions persist, a home water softener
Note:
should be considered.
Page 16