First Use; Personalisation - Zanussi ZKH 7146 J User Manual

Follow the product manufacturer's recommendations on
quantities to use and do not exceed the «MAX» mark in
the detergent dispenser drawer.
Garment labels
For drying, follow the indications given on the manufac-
turer's labels:
•
= May be tumble dried
•
= Drying at high temperature
•
= Drying at reduced temperature
•
= Do not tumble dry.
Drying cycle duration
The drying time may vary depending on:
• speed of the final spin

First use

• Ensure that the electrical and water connections
comply with the installation instructions.
• Remove the polystyrene block and any material
from the drum.
• Before the first wash, run a cotton cycle at the
highest temperature without any laundry in the

Personalisation

Acoustic signals
The machine is provided with an acoustic device, which
sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 3 and 4 buttons simultaneously for about
6 seconds, the acoustic signal is deactivated (except if
there is a fault). By pressing these 2 buttons again, the
acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appliance unattended
so you do not need to worry that children might be injured
12
• dryness degree required (iron dry, store dry)
• type of laundry
• weight of the load size .
The average drying time for a timed drying are indicated in
the «Drying programmes» chapter. The experience will
help you to dry your laundry in a more suitable way, ac-
cording to the different fabrics. Take note of the duration
drying time of the already performed cycles.
Additional drying
If the laundry is still damp at the end of the drying pro-
gramme, select a short drying cycle again.
Warning! Do not over dry the laundry in order to
avoid creasing of fabrics or garment's shrinking.
machine, to remove any manufacturing residue
from the drum and tub. Pour 1/2 a measure of
detergent into the main wash compartment and
start the machine.
by or cause damage to the appliance. This function re-
mains enabled also when the washing machine is not
working.
There are two different ways to set this option:
1. Before pressing button 7: it will be impossible to
start the machine.
2. After pressing button 7: it will be impossible to
change any other programme or option.
To enable or disable this option press simultaneously for
about 6 seconds buttons 2 and 3 until on the display, the
icon appears or disappears.