Where To Go From Here - HP ProCurve 420 Installation And Getting Started Manual

Table of Contents

Advertisement

Getting Started With Access Point Configuration

Where to Go From Here

The above procedure, using the CLI, configured your access point with a
manager password, IP address, and subnet mask. As a result, with the proper
network connections, you can now manage the access point from a PC
equipped with Telnet or a web browser interface. The above procedure also
configured the Service Set Identifier (SSID), radio channel, and enabled
wireless operation. Your wireless clients can now access the network by
setting their SSID and radio channel to the same values used by the access
point. Note that some wireless clients can be configured to scan all of the radio
channels for an access point and the SSID.
Some basic information on managing your access point is included in the next
section. For more information on the console and web browser interfaces,
and all the features that can be configured on the Access Point 420, please see
the Management and Configuration Guide, which is on the Documentation
CD-ROM that came with your access point.
To Recover from a Lost Manager Password: If you cannot start a con-
sole session because of a lost manager password, you can clear the password
and user name by getting physical access to the access point and pressing and
holding the Reset button for more than five seconds. However, note that this
action resets all configuration settings to the factory defaults.
3-7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents