Diagnostic Steps; Start Diagnosis Flowchart - HP ProLiant BL45p User Manual

86 HP ProLiant BL45p Server Blade User Guide
Check any interlock or interconnect LEDs that may indicate a component is
not connected properly.
If problems continue to occur, remove and reinstall each device, checking the
connectors and sockets for bent pins or other damage.

Diagnostic steps

To effectively troubleshoot a problem, HP recommends that you start with the
first flowchart in this section, "Start diagnosis flowchart (on page 86)," and
follow the appropriate diagnostic path. If the other flowcharts do not provide a
troubleshooting solution, follow the diagnostic steps in "General diagnosis
flowchart (on page 89)." The general diagnosis flowchart is a generic
troubleshooting process to be used when the problem is not server-specific or is
not easily categorized into the other flowcharts.
The available flowcharts include:
Start diagnosis flowchart (on page 86)
General diagnosis flowchart (on page 89)
Power-on problems flowchart ("Server blade power-on problems flowchart"
on page 91)
POST problems flowchart (on page 93)
OS boot problems flowchart (on page 95)
Server fault indications flowchart (on page 98)
The number contained in parentheses in the flowchart boxes corresponds to a
table with references to other detailed documents or troubleshooting instructions.

Start diagnosis flowchart

Use the following flowchart to start the diagnostic process.
Item
1
Refer to
"General diagnosis flowchart (on page 89)"