Kenmore 122.16500010 Use & Care Manual page 14

12. Side Burner Valve Installation
a). Loosen but do not remove the two Side Burner
attachment screws and washers beneath the Side Burner
Bowl. In addition, remove the 2 bracket screws on the Side
Burner Tube. See Fig. 22.
b). Remove two small screws pre-attached to the front of
Side Burner Valve. From back of front panel, first push Valve
Control Stem through front panel hole, and then insert Side C S f
Burner Valve into hole in end of Side Burner Tube. Place the
Bezel (Y) over the Valve Control Stem, and attach Bezel to
Front Panel and Valve with previously removed 2 screws
and washers. See Fig. 23.
c). Push Side Burner Control Knob (Z) onto Valve Control
Stem. Insert supplied Allen Key (EE) into set screw in Knob Stem Insert supplied Allen Key (EE) into set screw in Knob
and tighten to Stem. See Fig. 24
d). Connect the ignition wire tip coming from the Side Burner
to the wire tip coming from Main control panel.
See Fig. 25.
Fig. 22
S
Fig. 23
Fig. 24
Fig. 25
14
Y Y
Y
Z
EE