Care And Cleaning - Kenwood JK60 series Instructions Manual

key
lid
on/off switch
neon light
water level gauge
scale filter
2 cups
2 spoons
dual voltage selector
cord clip
to use your travel jug kettle
1 Remove the cups and spoons from
the kettle.
2 Select the required voltage by
turning the selector control
Always check that you have
selected the correct voltage
before using the kettle.
3 Fill it through the spout or lid. The
water level must be between "MAX"
and "MIN" (1 cup/approx. 200mls).
4 Check the lid is closed.
5 Plug in and switch on. The neon will
come on.
6 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
7 Always unplug the kettle after use.
Take care when using the cups and
do not overfill above the inner rim
(approx. 200mls).
Your kettle is fitted with a scale filter
to hold back limescale particles.
If you find drops of water under your
kettle, don't worry - it is just
condensation.
boil-dry protection
If you switch on with too little water,
your kettle will cut out automatically.
Switch off and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
approximate boiling times
220/240 volts approx 5 minutes for
450 mls (maximum)
110/120 volts approx 5 minutes 40
seconds for 450 mls (maximum)
.

care and cleaning

Before cleaning, unplug your kettle
and let it cool down.
The cups and spoons can be placed
in the kettle for compact storage.
Wrap the cord around the kettle and
secure using the cord clip
the outside
Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the plastic surfaces.
the inside
Wipe with bicarbonate of soda on a
damp cloth. Rinse thoroughly.
Even though your kettle comes with
a scale filter, you still need to clean
the inside (and the filter) regularly.
3
.