Canceling A Cycle; Changing A Cycle After Dishwasher Is Started; Adding A Dish After Dishwasher Is Started - Kenmore 665.1389 Use & Care Manual

Heated Dry
Turns the heat element on after the
wash cycle is completed. Use rinse
aid with or without the Heated Dry
option for best drying results.
Plastic items are less likely to
deform when loaded in the top dish
rack.
† The maximum additional water used for any combination of options is 2.8 gal. (10.6 L).
Delay Hours
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during
off-peak hours when possible. Be sure to press START/RESUME and firmly close the door within 3 seconds after
adding items.
To delay the start
1. Select a wash cycle and options.
2. Press the 4-Hour Delay button.
3. Press START/RESUME and close the door firmly within 3 seconds. The dishwasher starts in 4 hours.
NOTE: If anyone opens the door (such as, adding a dish, even during the Delay Hours option), the START/RESUME
button must be pressed again, and the door closed within 3 seconds to resume the cycle.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCK ON is lit, all
buttons are disabled. The dishwasher door can still be opened/closed while the controls are locked.
To turn on the Lock
Press and hold HEATED DRY for 3 seconds. LOCK ON will light up. If you press any pad while your dishwasher is
locked, the light flashes 3 times.
NOTE: The dishwasher cannot run if the control is locked.
To turn off the Lock
Press and hold HEATED DRY for 3 seconds. The light turns off.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press CANCEL/DRAIN button once. The Cancel/Drain light will light up.
3. Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let
the dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser
before restarting your new cycle.
3. Press CANCEL/DRAIN twice to reset the control.
4. Select new cycles and options.
5. Press START/RESUME and firmly close the door within 3 seconds.
NOTE: If the door is not closed within 3 seconds of pressing START/RESUME, press START/RESUME again.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check whether the detergent dispenser cover is still closed. If it is open, the wash cycle has already started and
adding a dish is not recommended.
3. If detergent has not yet been used (detergent dispenser cover is closed), you may add a dish.
4. Press START/RESUME and firmly close the door within 3 seconds.
14
Available with
any cycle
except
Quick Rinse

Canceling A Cycle

Changing A Cycle After Dishwasher Is Started

Adding A Dish After Dishwasher Is Started

Turns the heat element
on at the end of the
wash cycle.
26 26 0