Download  Print this page

NEC PlasmaSync 42VP4 (42Wide VGA) User Manual page 51

Hide thumbs

Advertisement

*1 Only when using a graphic accelerator board that is capable of displaying 852 480.
*2 This signal is converted to a 1024 dots
*3 The picture is displayed in the original resolution.
*4 The aspect ratio is 5:4. This signal is converted to a 960 dots 768 lines signal.
*5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the
RGB mode prepared for the input signals listed in the table above.
*6 To connect the monitor to Macintosh computer, use the monitor adapter (D-Sub 15-pin) to your computer's video port. If
your computer has a mini D-Sub 15-pin connector, you may have to use the supplied RGB cable.
*7 Other screen modes (ZOOM and STADIUM) are available as well.
NOTE:
• While the input signals comply with the resolution listed in the table above, you may have to adjust the position and size
of the picture or the fine picture because of errors in synchronization of your computer.
• When a 1280 dots
1024 lines signal or 1600 dots
compressed.
• This monitor has a resolution of 1365 dots
XGA, or equivalent.
• With digital input some signals are not accepted.
• The sync may be disturbed when a nonstandard signal other than the aforementioned is input.
• If you are connecting a composite sync signal, use the HD terminal.
* "IBM PC/AT" and "XGA" are registered trademarks of International Business Machines, Inc. of the United States.
* "Apple Macintosh" is a registered trademark of Apple Computer, Inc. of the United States.
640 lines signal.
1200 lines signal is input to the monitor, the picture will be
768 lines. It is recommended that the input signal should be XGA, wide
E-46
3-109
CONFIDENTIAL

Advertisement

loading

  Related Manuals for NEC PlasmaSync 42VP4 (42Wide VGA)