*1 Only when using a graphic accelerator board that is capable of displaying 852 480.
*2 Display only 400 lines (42Wide VGA), 640 lines (42XGA) with the screen center of the vertical orientation located at the
*3 42Wide VGA: The picture is displayed in the original resolution. The picture will be compressed for other signals.
*4 42XGA: The picture is displayed in the original resolution. The picture will be compressed for other signals.
*5 Aspect ratio is 5:4. This signal is converted to the following signal (42Wide VGA: 600 dots 480 lines, 42XGA: 720
dots 768 lines).
*6 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the
RGB mode prepared for the input signals listed in the table above.
*7 To connect the monitor to Macintosh computer, use the monitor adapter (D-Sub 15-pin) to your computer's video port. If
your computer has a mini D-Sub 15-pin connector, you may have to use the supplied RGB cable.
*8 Other screen modes (ZOOM and STADIUM) are available as well.
• While the input signals comply with the resolution listed in the table above, you may have to adjust the position and size
of the picture or the fine picture because of errors in synchronization of your computer.
• This monitor has a resolution of 853 dots 480 lines or 1024 dots 768 lines. It is recommended that the input signal
be VGA, wide VGA or equivalent for 42Wide VGA, XGA or equivalent for 42XGA.
• With digital input some signals are not accepted.
• The sync may be disturbed when a nonstandard signal other than the aforementioned is input.
• If you are connecting a composite sync signal, use the HD terminal.
* "IBM PC/AT", "VGA" and "XGA" are registered trademarks of International Business Machines, Inc. of the United States.
* "Apple Macintosh" is a registered trademark of Apple Computer, Inc. of the United States.