S BY S1
S BY S2
Switching the input source quickly
This feature enables quick input selection.
After setting ON, press the CLEAR/SEAMLESS SW
button for quick switching between the two selected input
Example: Set to switch quickly between RGB1 and
On "SEAMLESS SW" of "OPTION4" menu, select "ON".
Select "RGB1" and "RGB2".
* The available sources depend on the settings of input.
SEAMLESS SW Function
* This feature will not function for certain input
combinations. See the table on page En-15.
* After switching to the selected input, please operate this
* This feature will not function during split screen mode.
* When SEAMLESS SW is first turned on, or when
signals being transmitted are changed, there may be a
slight delay due to signal analysis.
SEAMLESS SW settings
OFF: Turns off the SEAMLESS SW function.
ON: When the CLEAR/SEAMLESS SW button is
pressed, input signals will switch quickly according to
the setting of SELECT1 and SELECT2.
4 / 4
S BY S1
Displaying the information as a text
Example: Setting "TEXT INSERT" to "BOTTOM",
"INPUT" to "RGB1", "PIC. RATE" to "100%" and
"DISPLAY" to "NORMAL"
On "TEXT INSERT" of "OPTION4" menu, select
"BOTTOM", then press the MENU/ENTER button.
The "TEXT INSERT" screen appears.
Adjust the items.
TEXT INSERT setting
OFF: Displays no text.
TOP/MID HIGH/MID LOW/BOTTOM: Displays a
text at the specified location.
Sets the input of the text to the RGB1 to 3.
PIC. RATE setting
Sets the transparency of the text.
NORMAL: The sub screen is displayed consistently.
FADE: The sub screen fades in.
Enhanced split screen Model