Canon LBP3360 User Manual page 269

Remedy 2 Perform a soft reset in the RESET menu, set GRADATION LEVEL (See p. 6-23)
<39 SPL MEM.FULL>
Cause
Remedy 1 The printer continues printing by pressing the
Remedy 2 Perform a soft reset in the RESET menu, specify the paper size smaller, and
Remedy 3 Perform a soft reset in the RESET menu, set GRADATION LEVEL (See p. 6-23)
Remedy 4 If 2-SIDED PRINT. in the FEEDER MENU options in the SETUP menu is set to
Remedy 5 Change the setting for HALFTONES (See p. 6-24) in the QUALITY MENU
<41 CHK PAPER SZE>
Cause 1
8
Remedy
Cause 2
Remedy
Cause 3
Remedy
8-32 Message List
in the QUALITY MENU options in the SETUP menu to STANDARD, and then
print again.
Because spool memory has run out, the printer cannot print.
page with which an error has occurred is not printed.
then print again.
in the QUALITY MENU options in the SETUP menu to STANDARD, and then
print again.
ON, specify OFF, and then print again.
options in the SETUP menu, and then print again.
The size of the paper loaded in the manual feed slot or paper cassette is
different from the setting for SLOT PAPER SIZE, CASSETTE1 SIZE, or
CASSETTE2 SIZE specified from the computer or control panel.
Match the size specified in SLOT PAPER SIZE, CASSETTE1 SIZE, or
CASSETTE2 SIZE and the size of the loaded paper, and then press the
(Online) key.
You are using UFR II Printer Driver, and you loaded custom paper of its long
edges 215.9 mm or less and printed when SLOT PAPER SIZE, CASSETTE1
SIZE, or CASSETTE2 SIZE in the FEEDER MENU options in the SETUP menu
was set to MIXED SIZE.
Load the paper in landscape orientation, then print again.
SPECIAL MODE J in the USER MAIN. options in the SETUP menu is set to
OFF.
Set SPECIAL MODE J (See p. 6-31) to ON, then print again.
<Auto Error Skip>
(Online) key. However, the