Canon LBP3360 User Manual page 176

GUTTER
-50.0 to 50.0; 0.0* (mm)
Specifies the gutter width for printing with the binding location created. A gutter is
created with the image shifted by the specified value. You can shift the image in
the "+" direction with a positive value and in the "–" direction with a negative value.
[0 mm]
Center
Specify on which edge of the paper, the long edge or short edge, the gutter is to
be created in BIND.LOCATION (See the previous item). On which edge (top/
bottom/left/right) of the paper the gutter is created depends on the setting for
BIND.LOCATION and which value "+" or "-" is specified for this item.
IMPORTANT
If any part of the print image lies outside the printable area after creating a gutter,
the part will be missing in the print result.
NOTE
Each time you press [
•
time you press [
holding down [
If the settings for OFFSET Y and OFFSET X are specified at the same time as the
•
setting for this item is specified, the settings for OFFSET Y and OFFSET X are
processed first, and then the setting for this item is processed.
+ direction
Center
], the value increases in 0.5 mm increments, and each
], the value decreases in 0.5 mm increments. If you keep
] or [ ], the speed of the value changing is increased.
- direction
Center
SETUP Menu Settings
6
6-21