Yamaha SWK-W10 Owner's Manual page 6

4 Connect the cables in the following order.
1 Connect the AUDIO OUTPUT (SUBWOOFER) of
this unit and the input jack of your subwoofer using a
subwoofer cable.
2 Plug the power cable of your subwoofer to the AC
OUTLET terminal of this unit.
3 Plug the power cable of this unit to an AC wall outlet.
1
A B
L L
MONO
R R
INPUT INPUT
3 2
Subwoofer
(with internal amplifier)
Note
• Do not plug a subwoofer which power
consumption is higher than 100 W to the AC
OUTLET terminal of this unit.
5 Turn on the subwoofer.
6 Set the volume of your subwoofer to
about half way and then set the crossover
frequency to the maximum.
VOLUME
MIN MAX
Subwoofer
4
En
To AC wall outlet
L
/ SUBWOOFER
1 2 3
R
GROUP ID AUDIO OUTPUT AC OUTLET
This unit
2
CROSSOVER/
HIGH CUT
MIN MAX
7 Turn on the transmitting-side product.
The LED turns to green if a wireless connection
between this unit and transmitting-side product is
established.
Status LED
3
LED
Red
Orange
Green
Note
• If your subwoofer is operable with the remote
control, set the subwoofer's power management
setting to "Always On" to make the power control
of this unit functions properly.
Status
This unit is turned off because the
transmitting-side product is also
turned off. Turn on the
transmitting-side product to turn
on this unit.
A wireless connection is being
established. Please wait.
A wireless connection is
established properly.