Omron SYSDRIVE 3G3MV SERIES User Manual page 325

List of Parameters
Para Reg- Name
me- ister
ter No.
No. (Hex)
n098 0162 Overtorque
detection
level
n099 0163 Overtorque
detection
time
n100 0164 UP/DOWN
frequency
memory
n101 0165 Speed
search de-
celeration
time (See
note.)
n102 0166 Speed
search op-
erating lev-
el (See
note.)
n103 0167 Torque
compensa-
tion gain
n104 0168 Torque
compensa-
tion pri-
mary delay
time con-
stant
n105 0169 Torque
compensa-
tion core
loss
n106 016A Rated
motor slip
Note Speed search deceleration time and speed search operating level can be set for 5.5-kW and
7.5-kW Inverters only.
Description
Used to set overtorque detection level.
Detection from output torque: Set as a percent-
age based on the rated motor torque as 100%.
Detection from output current: Set as a per-
centage based on the rated Inverter output cur-
rent as 100%.
Used to set the detection time for overtorque.
Used to store the adjusted frequency reference
with the UP/DOWN function.
0: Frequency not stored
1: Frequency stored
The frequency must be on hold for 5 s or
more.
Sets the speed search deceleration time as the
time required to go from 100% to 0% of the
maximum frequency.
This is a constant for adjusting the speed
search function. If "0.0" is set, the Inverter will
operate at the default time of 2.0 seconds.
Sets the speed search operating level as a
percentage, taking the Inverter's rated output
current as 100%.
This is a constant for adjusting the speed
search function. If the Inverter output current
falls below the set value, the speed search will
be judged as completed and acceleration will
begin again.
Used to set the gain of the torque compensa-
tion function.
* The default setting does not need any chan-
ges in normal operation.
Sets the response speed of the torque com-
pensation function.
* Normally, the default setting does not need
to be changed.
Sets the core loss of the motor in use.
* Normally, the default setting does not need
to be changed.
* This parameter is enabled in V/f control
mode only.
Used to set the rated slip value of the motor in
use.
* Used as the constant of the slip compensa-
tion function or vector control.
Chapter 10
Set- Unit Defa Chan-
ting of ult ges dur-
range set- set-
ting ting opera-
30 to 1% 160 No
200
0.1 to 0.1 s 0.1 No
10.0
0, 1 1 0 No
0.0 to 0.1 s 2.0 No
10.0
0 to 1 % 150 No
200
0.0 to 0.1 1.0 Yes
2.5
0.0 to 0.1 s 0.3 No
25.5
0.0 to 0.1 W Varies No
6,550 with
the
capac-
ity.
0.0 to 0.1 Varies Yes
20.0 Hz with
the
capac-
ity.
Ref-
er-
ing ence
page
tion
6-32
6-32
6-45
5-35
5-35
6-35
6-35
6-35
6-37
10-23