Changing Oven Light - Frigidaire 318205829 Use & Care Manual

CARE & CLEANING
Around
Oven door
Hinge
Figure 3
Special door care instructions -
doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are
fully in place.
2. Do not hit the glass with pots, pans, or any other
object.
3. Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of
breakage at a later time.
To remove and replace storage drawer
Use the storage drawer for storing cooking utensils. The
drawer can de removed to facilitate cleaning under the
range. Use care when handling the drawer.
Removing and Replacing Storage Drawer
To remove the drawer:
1. Pull empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the
rollers to clear the roller guide stop, and push in.
Roller
Roller
Guide
Front
Frame
24

Changing oven light

Be sure the oven is unplugged and all parts are COOL
before replacing the oven light bulb. Do not turn
the oven light on during a self-cleaning cycle. High
temperature will reduce lamp life.
On some models an interior oven light will turn on
Figure 4
automatically when the oven is opened. The oven light
may be turned on when the door is closed by using the
Most oven
oven light switch located on the Electronic Oven control.
The oven light bulb is covered with a glass shield held
in place by a wire holder. THIS GLASS SHIELD MUST
ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
BE SURE OVEN IS COOL
To Replace the Light Bulb:
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against
3. Replace bulb with a 40 Watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side
Storage
Drawer
CAUTION
CAUTION
possible broken glass.
to release glass shield, change bulb and be sure to
replace glass shield.