French rating g
The V-Chip can block non rated programs as per "CEA-608-E
sec. L.3". If the option to block NR, None or E programs is
used in US Movie ratings lock, US TV ratings lock, Canadian
English rating or Canadian French rating accordingly "unusual
results may occur and the unit may not receive emergency
bulletins or other types of programming" : Emergency Bulletins
(Such as EAS messages, weather warnings and others) / Locally
originated programming / News / Political / Public Service
Announcements / Religious / Sports / Weather.
Setting your location to home
You can set the location of your TV to Home or Retail.
Choosing Home gives you full ﬂ exibility to change
predeﬁ ned settings for picture and sound.
Press MENU and use ▲▼ to select Features, then
Use ▲▼ to select Location, then press OK.
Use ▲▼ to select Home, then press OK.
You must set Home. Otherwise, personalized picture and sound
settings will not be memorized after the unit goes into Standby mode.
Viewing photos and watching videos on
a USB Memory Stick
Your TV is ﬁ tted with a USB connection that enables you to
view photos or watch videos (Motion JPEG ﬁ les) stored on
a USB Memory Stick.
Press MENU and use ▲▼ to select USB, then press OK.
The highlighted text will move to the name of your USB
Memory Stick, then press OK again.
Locked all ratings
For all children
For children over 8
Unsuitable for ages under 8
Parental guidance suggested
Unsuitable for ages under 13
Unsuitable for ages under 14
Unsuitable for ages under 16
Adult audience only
Use ▲▼ to select the Picture or Video, then press OK.
The ﬁ les recorded under the following speciﬁ cations are
Picture (JPEG) Upper limit 24Mpixel
Frame rate 30fps
Audio type LPCM
We cannot be held responsible if your USB Memory Stick is
not supported, nor will we accept any liability for damage or
loss of stored data.
The USB Memory Stick is not supplied with this TV.
A ﬁ le name exceeding 128 characters or contains a dot
character is not supported on this TV.
Progressive JPEG ﬁ les are not supported.
Only a Motion JPEG ﬁ le with an ".avi" extension is supported.
An extension ".mov" is not supported.
During Motion JPEG playback, "Pause", "Forward" and "Reverse"
do not work on this
5 Install channels
Be sure the RF cable is correctly connected to this unit and
you are registered with your cable TV provider when you
install Cable channels.
Press MENU and use ▲▼ to select Setup, then press OK.
Use ▲▼ to select Autoprogram, then press OK.
If you run Autoprogram when you have locked channels, a
message appears asking to enter your PIN . Enter your PIN in
order to complete the installation. You need to set the channel
lock again after the installation.
Use ▲▼ to select an appropriate option, then press
When Antenna is selected, the TV detects antenna signals. It
searches for ATSC and NTSC channels available in your area.
When Cable is selected, the TV detects signals supplied by
cable. It searches for ATSC, NTSC and Cable channels available
in your area.
Autoprogram will rescan all channels.
Auto programming may take more than 20
minutes to complete.
Select your signal source.
When the scanning and memorizing are completed, the lowest
memorized channel will be displayed.
Follow the on-screen instructions to complete the
320 x 240 (QVGA)
(32 kHz, 44.1 kHz or 48 kHz)
Quantization bit rate (16 bit)