Brother DCP-365CN Quick Setup Manual page 12

USB
For USB interface users (Mac OS X 10.3.9 - 10.4.x - 10.5.x)
10
Before you install
a
Make sure your machine is connected to the
power and your Macintosh is ON. You must be
logged on with Administrator rights.
IMPORTANT
• For the latest drivers and information on the
Mac OS X you are using, visit
http://solutions.brother.com/.
• For Mac OS X 10.3.0 to 10.3.8 users, upgrade
to Mac OS X 10.3.9 - 10.5.x.
• Make sure there are no memory cards or a
USB Flash memory drive inserted into the
machine.
11
Connect the USB cable
IMPORTANT
• DO NOT connect the machine to a USB port
on a keyboard or a non-powered USB hub.
• Connect the machine directly to your
Macintosh.
a
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
12
b
Connect the USB cable to the USB socket
marked with a
USB socket inside the machine on the right as
shown below.
LAN USB
c
Carefully guide the USB cable through the
trench as shown below, following the trench
around and toward the back of the machine.
Then connect the cable to your Macintosh.
IMPORTANT
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Macintosh
symbol. You will find the