For The Installer; Technical Information; Installation; Unpacking - Zanussi TL493 Instruction Book

Technical information

Dimensions
Power supply voltage / frequency
Total power absorbed
Heater rating
Water pressure
Maximum load
Spinning speed
Electrical consumption (washing at 60°C)
This appliance complies with the following EC Directive :
- 72/23/EEC of 19.02.1973 - Low-Voltage Directive
- 89/336/EEC of 03.05.1989 (including Amentment Directive 92/31/EEC) - EMV Directive.

Installation

Unpacking

The parts protecting the inner components of
the machine during transit are red. They must
all be removed before using your machine for
the first time. These parts and their securing
means should be kept in case the machine has
to be transported again.
Unpack the appliance. Tilt the appliance
backwards. Give to one of the back corners a
quarter turn. The appliance comes free naturally
out the polystyrene basis. Take away this basis
(fig. 1).
Open the lid of the appliance and remove the
polystyrene and red plastic wedges which block
the drum. Close the lid (fig. 2).
On the back part and with a spanner, remove
the two red loosened spacers (A) (fig. 3).
The holes which are now visible must be closed
with the plugs (B) provided with the appliance
(fig. 4).
Please ensure that these parts have been
removed from the machine and keep them in
case of next transport (fig. 5).
If you want to keep the alignment of your
appliance with the adjacent cupboards, you
have the possibility to cut the crossbar holding
the hoses located at the back of your washing
machine (fig. 6).

FOR THE INSTALLER

height with panel
height without panel
width
depth
minimum
maximum
cotton
synthetics
wool
895 mm
850 mm
397 mm
600 mm
230 V / 50 Hz
2300 W (10 A)
1950 W
0,05 MPa (0,5 bar)
0,8 MPa (8 bar)
4,5 kg
2,0 kg
1 kg
400 rpm
1,3 kWh
Fig. 1
A
Fig 3
Fig 5
Fig. 2
B
Fig 4
Fig 6
37