Something Not Working - Zanussi F906CN Instruction Booklet

Washing machine f 906 cn
Table of Contents

Advertisement

Problems which you can resolve yourself
Problem
I
The machine does not start up:
I
The machine does not fill:
I
The machine fills then empties
I
immediately:
The machine does not empty
I
and/or does not spin:
There is water on the floor:
I
Unsatisfactory washing results:
I

SOMETHING NOT WORKING

Possible cause
I
I
Check that the door is firmly closed.
I
Check that the machine is plugged in and
that there is power at the socket.
I
Check that the main fuse or the fuse in the
plug has not blown.
I
Check that the programme selector dial is
positioned correctly and the ON/OFF button
depressed.
I
Check that the water tap is open.
I
Check that water is coming out of the tap.
I
Check that the inlet hose is not squashed or
kinked.
I
Check that the filter in the inlet hose is not
blocked.
I
Check that the door is closed.
I
The end of the drain hose is too low. Refer to
relevant paragraph in "water drainage"
section.
I
Check that the drain hose is not squashed or
kinked.
I
The anticrease
I
The laundry is not evenly distributed in the
drum.
I
Too much detergent or unsuitable detergent
(creates too much foam) has been used.
I
Check whether there are any leaks from one
of the inlet hose fittings. It is not always easy
to see this as the water runs down the hose;
check to see if it is damp.
I
Check that the drain hose is not damaged.
I
Too little detergent or unsuitable detergent
has been used.
I
Stubborn stains have not been treated prior
to washing.
I
The correct temperature or programme was
not selected.
19
option has been selected.

Advertisement

Table of Contents
loading

Table of Contents