Table of Contents
Advertisement
HOW TO USE YOUR TUMBLE DRYER
Before using your tumble dryer for
the first time
There may be dust or dirt inside a brand new tumble
dryer. Place a few damp cloths inside the appliance
and dry for approximately 20 minutes.
1. Loading laundry
Open door by pressing the appropriate button. Load
spun laundry. Do not press laundry in appliance. Close
door making sure that there are no laundry items
preventing the door from being closed.
2. Select drying time
Turn dial clockwise until the desired drying time is
under the symbol on the front panel (see programme
chart). The mains-on light will then light up.
P0555
3. Press "low temperature" button,
if necessary.
4. Start programme
Press start button; the appliance will start functioning.
The selected drying time may also be changed after
the programme has started. In order to do this, re-set
dial.
5. End of cycle
When the selected cycle has come to an end, the
tumble dryer will stop and the mains-on light will
switch off automatically. The selector dial will return
to the 'zero' position.
Open door and take out cooled laundry.
IMPORTANT! Clean filter and empty water
container after every drying programme.
57
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TCS 673 T and is the answer not in the manual?
Questions and answers
luz acesa tanque cheio ,bomba nao funciona !!
The Zanussi TCS 673 T may show the "Water container full" light because the water container is full and needs to be emptied. If the pump is not working, it could be due to a blockage or malfunction. Check the following:
1. Empty the water container: Refer to the cleaning instructions in the manual to empty the container properly.
2. Inspect for blockages: Ensure there are no obstructions in the drainage system or pump.
3. Verify proper installation: Confirm the appliance is installed on a flat, level surface with adequate ventilation.
4. Contact service: If the issue persists, contact a Zanussi Service Centre with the product, model, and serial numbers from the rating plate.
This answer is automatically generated