Tools Required; Mounting - Honeywell W180 User Manual

Fig. 12—Automatic opposed blade damper-bottom mount dimensions.
1
2
8
[54]
HEIGHT DIMENSIONS:
TO ENSURE PROPER FIT, ACTUAL DAMPER HEIGHT IS 1/8 INCH [3 MILLIMETERS] LESS THAN LISTED HEIGHT DIMENSION.
WIDTH DIMENSIONS: 8, 10, 12, 14, 16, 18, AND 20 INCHES [203, 254, 305, 356, 406, 457, 508, MILLIMETERS].
TO ENSURE PROPER FIT, ACTUAL DAMPER WIDTH IS 3/16 INCH [5 MILLIMETERS] LESS THAN LISTED WIDTH DIMENSION.
1 ADDITIONAL SIZES AVAILABLE (HEIGHT X WIDTH): 16X16, 16X18, 16X20, 18X18, 18X20, 20X20.
SIZES NOT AVAILABLE (HEIGHT X WIDTH): 10X8, 12X8, 12X10, 14X8, 14X10, 14X12.
2 LISTED DAMPER WIDTH = ACTUAL AIR DUCT WIDTH

TOOLS REQUIRED

The following tools and equipment are required to in-
stall a W180 Zone Control System:
— Hammer
— Screwdriver (flathead)
— Pliers
— Wire cutters
— Wire strippers
— Electric drill
— Sheet metal shears
HEIGHT
AIR DUCT
3
2
8
[60]
1
3
4
[83]
6, 8, 10, 12, AND 14 INCHES [152, 203, 254, 305, 356, MILLIMETERS].
5
3
8
[92]
5
[127]
LISTED
2
DAMPER
WIDTH
1
— Utility knife
— Voltmeter/multimeter
— Thermometer
— 3/4-inch plywood (20 in. by 17 in.) and mounting
hardware suitable for the wall on which the W180A
Controller enclosure will be mounted.
NOTE: Studs at 16 in. o.c. may also be used for

mounting.

15
W180 ZONE CONTROL SYSTEM
WIDTH
1
M2270A
68-0139