Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Service door (see
●
WLAN module (see
●
Top cover (see
●
System board (see
To remove the power connector cable:
1.
Position the system board upside down.
2.
Disconnect the power connector cable (1) from the system board.
3.
Release the power connector cable from the clips (2) built into the fan.
86
Chapter 4 Removal and replacement procedures
Battery on page
43), and then remove the following components:
Service door on page
49)
WLAN module on page
Top cover/keyboard on page
System board on page
52)
55)
73)
Spare part number
747116-001