Encoding Page - JVC VN-H37U Instructions Manual

Internet Explorer Setting
Settings (continued)

Encoding Page

This page sets JPEG/H.264/MPEG-4 encoding parameters.
This entry links to the [Encode] item of "Basic Setting2" page. (A Page 17)
This page can be used during access using AadminB or AoperatorB.
Click [Advanced Settings] and [Encoding].
Memo:
● Press the [OK] button to enable the new settings.
● If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the
change was made. If you press the [Cancel] button, other changed items will also be restored to the
values before the change was made.
● Encoding settings cannot be changed during multicast distribution. (A Page 66)
● If settings on this page are altered during playback using the Built-in Viewer, reboot the viewer.
● There is upper limit to transmission bit rate from the camera. If a bit rate that exceeds upper limit is
specified, this new setting will not be applied. For details on the maximum transmission limit, refer to
the section on "Network". (A Page 4)
● H.264 High indicates High Profile, and H.264 Baseline indicates Baseline Profile.
● The contents displayed in C changes depending on the type of encoding and the item selected.
● If the distribution bit rate exceeds 24 Mbps, the specified frame rate distribution fails.
26
A
B
C
D