Wash System; Operating Instructions - Kenmore 587.1521 Series Use & Care Manual

Operating Instructions

Operating Instructions Operating Instructions
Operating Instructions Operating Instructions
Vent
P W
RECISION ASH

Wash System

Your Kenmore dishwasher filters 100% of the water
for optimum cleaning. The wash system uses
alternating arms to save water and energy and
includes a heavy-duty stainless steel food disposer
that grinds up large food particles.
How the wash system works
1. Load the dishwasher (See Preparing and Loading
Dishes).
2. Hot water enters the dishwasher, covers the filter,
and rises to the bottom of the heater clips.
3. Detergent is dispensed at the appropriate time and
mixed with the hot water. This mixture is pumped
through the lower spray arm and sprays against the
soiled surfaces of the dishes to remove food
particles.
4. Water passes through the fine mesh primary filter
where food soil is removed and the clean water is
then recirculated.
5. Ports under the lower wash arm direct the food soil
through a secondary filter into a collection chamber.
6. Food soil is held in the collection chamber until it is
flushed away during the drain cycle.
7. Clean, hot water enters the dishwasher and the
sequence is repeated.
8. Beginning with the third water fill, the wash action
switches between the lower spray arm and middle
spray arm in 90 second intervals. You may notice a
change in sound as the wash action pauses and
switches to the other arm.
9. The dishwasher may pause during the cycle while
water is being heated. Wash action will continue
during this time.
10. Rinse aid is automatically dispensed in the final
rinse to aid in drying.
Latch
CYCLES
Heavy Normal Eco Upper Quick
Wash Wash Wash Rack Rinse
Appearance may vary from your model.
Getting Started
1. Load dishwasher (See Preparing and
Loading Dishes).
2. Add detergent (See Dishwasher
Dispenser & Detergents).
3. Add rinse aid, if needed (See Rinse Aid).
4. Select desired CYCLE (See Cycle Chart).
The indicator will glow when selected.
5. Select desired OPTIONS (See Option
Selections). The indicator will glow when
selected.
6. If using WASH DELAY, follow Delay Start
instructions on page 9.
7. Run hot water faucet nearest dishwasher
until water is hot. Turn water off.
8. To start, press START/CANCEL pad.
Status Indicator Lights
The WASHING light comes on at the beginning of cycle
and remains on until the end of the final rinse.
The DRYING light indicates the drying portion of the
cycle. The light will come on when either drying option is
selected.
When the SANITIZE option is selected, the SANITIZED
light will glow when the SANITIZE cycle is finished. If the
dishwasher did not properly sanitize the dishes, the light
will not come on. This can happen if the cycle is
interrupted. The light will remain on until the door is
opened.
The CLEAN light will come on at end of cycle and
remain on until door is opened.
7
OPTIONS
2 4 6
Washing
Drying
Hi Heat Delay
Sanitize
Temp Dry Hours
Clean
hold
3 sec
Sanitized
START
STOP