4.6
Position Setup
This is where you enter your position, automatically or manually.
1. Press the MENU key at the standby display.
2. Rotate the CH knob (or press up / down arrow key) to choose POSITION
from the second page of the main menu.
3. Press the ENT key. The following menu appears.
4. INPUT TYPE is selected; press the ENT key. The following setting window
appears.
Note: If the position data from a positioning sensor is available, MANUAL can
not be chosen, i.e. the above window does not open.
5. Rotate the CH knob (or press up / down arrow key) to choose AUTO or
MANUAL as appropriate and press the ENT key.
If you chose AUTO, your ship's position and time appear; press the CANCEL
to close the menu and return to the standby display. These data are supplied
from the navigation equipment connected.
Note: ● If correct position data is entered from a position source during the
If you chose MANUAL, enter your position and time as follows.
6. Enter latitude (in eight digits) with the numeric keys. If necessary, switch
coordinates: 1 key to switch to North; 2 key to switch to South.
7. Press the ENT key and enter longitude (in nine digits) with the numeric keys.
If necessary, switch coordinates: 1 key to switch to East; 2 key to switch to
West.
8. Press the ENT key and enter UTC time with the numeric keys.
9. Press the ENT key and CANCEL key to finish.
**** SETUP MENU ****
POSITION
RTC
PRINT OUT
VOLUME
AUTO CH
INPUT TYPE: AUTO
LAT : -- -- ----
LON :
TIME : -- : --
setting of MANUAL, the setting changes automatically to AUTO from
MANUAL.
● If the message "EPFS ERROR" appears after you change INPUT
TYPE from MANUAL to AUTO, confirm that the navigation device is
functioning.
°
'
N
.
°
'
E
--- -- . ----
AUTO
MANUAL
4. BASIC SETUP
4-11