Table of Contents
Advertisement
Technical information
Dimensions
Power supply voltage / frequency
Total power absorbed
Heater rating for washing
Heater rating for drying
Water pressure
Maximum load for washing : cotton
Maximum load for drying :
Spinning speed
Electrical consumption (washing at 60°C)
This appliance complies with the following EC Directive :
- 72/23/EEC of 19.02.1973 - Low-Voltage Directive
- 89/336/EEC of 03.05.1989 (including Amentment Directive 92/31/EEC) - EMV Directive.
Installation
Unpacking
The parts protecting the inner components of
the machine during transit are red. They must
all be removed before using your machine for
the first time. These parts and their securing
means should be kept in case the machine
has to be transported again.
Unpack the appliance. Tilt the appliance
backwards. Give to one of the back corners a
quarter turn. The appliance comes free naturally
out the polystyrene basis. Take away this
basis (fig. 1).
Open the lid of the appliance and remove the
polystyrene wedge which blocks the drum.
Close the lid (fig. 2).
On the back part and with a spanner, remove
the two red loosened spacers (A) (fig. 3).
The holes which are now visible must be closed
with the plugs (B) provided with the appliance
(fig. 4). Do not forget to put the central cover.
Please ensure that these parts have been
removed from the machine and keep them in
case of next transport (fig. 5).
If you want to keep the alignment of your
appliance with the adjacent cupboards, you
have the possibility to cut the crossbar holding
the hoses located at the back of your washer-
dryer machine (fig. 6).
18
FOR THE INSTALLER
height with panel
height without panel
width
depth
minimum
maximum
synthetics
wool
cotton
synthetics
895 mm
850 mm
450 mm
600 mm
220 V / 50 Hz
2200 W (10 A)
1950 W
1320 W
2
5 N/cm² (0,5 kg/cm
)
80 N/cm² (8 kg/cm
2
)
5 kg
2,5 kg
1 kg
2,5 kg
1,5 kg
1000 rpm
1,2 kWh
Fig. 1
A
Fig 3
Fig 5
Fig. 2
B
Fig 4
Fig 6
Advertisement
Table of Contents
