Water Inlet; Water Drainage - Zanussi WJS 1272 Instruction Booklet

Water inlet

Connect the water inlet hose to a tap with a 3/4"
thread spout.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply loosen
the fitting, rotate the hose and retighten the fitting,
making sure there are no water leaks.
The inlet hose must not be lengthened. If it is too short
P0351 P0021
and you do not wish to move the tap, you will have to
purchase a new, longer hose specially designed for
this type of use.

Water drainage

The end of the drain hose can be positioned in three
ways:
Hooked over the edge of a sink using the plastic
hose guide supplied with the machine. In this case,
make sure the end cannot come unhooked when the
machine is emptying.
This could be done by tying it to the tap with a piece
P0022
of string or attaching it to the wall.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a height of not less than
60 cm and not more than 90 cm.
The end of the drain hose must always be ventilated,
i.e. the inside diameter of the drain pipe must be
larger than the outside diameter of the drain hose.
The drain hose must not be kinked. Run it along the
P0023
floor; only the part near the drainage point must be
raised.
Waterstop
The inlet hose is provided with a water stop device,
which protects against damages caused by water
leaks on the hose itself which could develop due to
natural ageing of the hose. This fault is shown by a red
sector on the windows "A".
Would this occour, turn the water tap off and refer to
your Service Agent to replace the hose.
A
P1045
8