Advertisement
Quick Links
GEWINO STARTED
1. Charge the Power Pack
n .
1. Plug charger into a 120V
household OuUet.
2. Charge the power pack for 4hfs.
Nore:
Pack
is
MI
charged
when
new.
3. Alter charging for 4hrs, unplug
charger and disconnect pack.
4. IMPORTAM: The first 3 times you
charge the battery, charge for at
least 5.5 hours in order to condiliw
the battery, and run battery until it
is fully exhausted.
RUNNING TIME
Appoximale running
tvne
is 12-18 min. Power
-.+may
quit suddenly. Let pack cool, then
recharge after removing pack trom vehicle.
CAUTION
W
DO not remove
warm
or hot p w e ! packs. Walt 20 m a n
unll
pack
has cooled Recnarging
loo
early w~ll Ylorlen pack llle
Recharging near lire orhigh teripralure is dangerous..
Do not recharae Dacks lhal show wear or leakaae.
Always unpnu<ciwer pack when not ~n use.
Do not dmpose of pack in fire, explosm or personal illpry may occur.
D~spose ol power packs properly, do not aisassemble.
.
Always remove power pa& from vehicle belore charging.
Do n6t
use
charger fwany use other than inshuctedin riirectimns.
2. Install Battery In Hand Controller
1. Remove
cover
ol battery
.
compartment on the
hand remote.
2. lnserl one 'W16LR61
Heavy Duly Battery.
3.
0%
sure
the
+
and
-
are
properly
matched.
NoIe
FOR
BEST
PERFORMANCEALWAYS
USE
ALKALINE
BAl7ERIES.
3. Install Charged Power
Pack
in Vehicle
TO INSERT BATTERY
1. Unlock battery door
by tuning latch to
the right.
4.
2. Siide fully charged
Ni-Cd Battery
pack forward.
3.
Relock the battery door.
TO REMOVE BATTERY
1.
Unlatch battery door.
2.
Slide battery backward.
To ensure proper function
*Do not mix old and new batterres.
-Do not mix alkaline, standard, or rechargeable batteries.
.Batteries installation should be done by an adult.
-Non.rechargeable balteries are not
to
be recharged.
-Rechargeable balteries are to be removed trom the toy betore being
recharged (if removable).
.Rechargeable batteries are only to be charged underadun supervision
lil
removable1
. ~ h ~ n ~ b # ~ e s a m e o r - a l e n ( v p e ~ r e c o m m e n d e d a r e b b e m
.Ballr~~es are to be lnseneo u.lh correct pdanty.
.Exhausted ballenes are to be remoied trom the toy
.The supply terminals are not to be shorl.circuited.
Driving
1 . Tum On/OH switch
on vehicle to the
On position.
2.
Operation
3. When you're done driving your Havoc
RC turn the On/OH switch
I ,I
II
I
.I,
I
,I
I
I,
.
I
)
/ .
Advertisement
Summary of Contents for Tiger Electronics Havoc 4 Motor Drive 67865
- Page 1 GEWINO STARTED 1. Charge the Power Pack 1. Plug charger into a 120V household OuUet. 2. Charge the power pack for 4hfs. Nore: Pack charged when new. 3. Alter charging for 4hrs, unplug charger and disconnect pack. 4. IMPORTAM: The first 3 times you charge the battery, charge for at least 5.5 hours in order to condiliw the battery, and run battery until it...
- Page 2 SAFETY Aduffi. (ha toy is recommended lor chddren age revlew all operating instructions and safety guidelines. Operating And Caring For Havoc DO NOT drive Havoc on streets. Streets are for real cars only. Always operate your vehicle within a range of 50 feet from you. Always store your vehicle in a cool, dry place and ON of painted or varnished surfaces.
- Page 3 Parent should examine lhe unlt ano cnarger penodlcally, mere is anv damacle. tov must not be used ~ n b i thel damaoe been properlyrepaired.- CARE AND USE MAINTENANCE : Clean the unit with a soft, damp cloth. Please do no? put the unit in direct sunlight or near any source of heat.