Billion BiPAC 7300GX Quick Install Manual page 10

2.2 Setting up your 3G connection:
You can configure your 3G connection to act as a backup (Autofailover mode),
or as your primary connection.
In both cases your 3G datacard with SIM must be inserted firmly into the
slot in the back of the router before powering up the device.
If your have completed your ADSL and wireless configuration and your 3G
datacard was inserted when you first powered up the router, please select Status
from the menu on the left-hand side and go to section 2.3 to configure your 3G.
If you have configured your ADSL and wireless without inserting your 3G
datacard the Status page of the router should look like this.
1. In this case, please click Logout and power down the router.
2. Now insert you 3G datacard firmly into the slot in the back of the router,
ensuring any "flip-up" antenna is deployed, and turn the device back on. The 3G
light will flash and then should turn solid within 1 min (depending on your signal
strength). Please wait for the DSL light to turn solid. This may take 1-2 mins.
3. Your ADSL line will reconnect and you will need to access the router again
by typing http://192.168.1.254 in the address bar and logging in.
4. This should bring you to the router's Status page. You are now ready to
configure your 3G connection.
10